Imagine that your bathtub is in dire need of replacement but don’t wish to waste your whole weekend doing more of these tedious and boring job? If the answer is yes then Tub reglazing is only the right option in your case. This may not take you more then 4 to five hours and your bath tub will likely be as good as new.
You might be wondering if you can do the daunting task of reglazing on your own. The reply is, you probably will if you take care of a few things. The first thing that you have to remember while reglazing is your own safety. This may end up being fatal if all thecorrect protective measures will not be taken. You need to cover every possible part if your body as the chemicals used in the act is toxic. It is preferable that you do the task in the open area.
You are now armed for resurfacing tub The initial step is always to clean your tub thoroughly You should clean remove the gasket and also the caulk when you rinse the tub. You are able to see a wide range of chemicals in the bath refinishing kit. Out of all the chemicals the first and the 2nd are for the purpose for cleaning. You’ll use the 1st chemical to scrub th face in the tub and also the second solution you can make the surface sore and rough.
You have to then be sure that no oil can there be on any part of thebathtub. If there is oil then this “primer” will be unable to grip properly. Next, you need to use the third solvent to get rid of the remaining sediment if any. Now the outer lining is ready for the “primer”. Withf paper towels you need to spread the reducer. You’ll have to then leave the solution on the tub for around thirty minutes. Then you need to clean with primer reducerto make sure that the surface is totally dry. You must rinse the tub many times to ensure dryness.
Next, be sure to hide the outer lining area with bathtub refinishing in areas where it has not been applied. These areas need to become cautiously wrapped with paper tape. You must check the seal carefully. You need to apply base coat for the tub after sealing over remianing area. During this time ventilation is essential and you should use respirators if you have them at your home. You need to read through the manual thoroughly while mixing the primer’s component. You’ll be able to spray t in the tub using a spraying gun or something just like that.
You’re nearly done with refinishing. Your next job would color your tub. Here you can let your imagination run wild and you will also choose prints. However follow the instructions carefully while mixing the painttogether to the topcoat. Apply the topcoat after thirty minutes have passed from your time of applying the primer. You can use a sprat gun to make use of the topcoat. You’re completely done now. Wait for around 72 hours before you step into your all new reglazed bathtub.
